|
We are not responsible for any
injury to yourself or others, any damage to your wall, you tools, or your wall
safe. These directions are only to assist with installation.
If you need more help
than these instructions provide, call Vline 1-805-520-4987
To install the Closet Vault in between wall
studs:
1. Check desired wall location to be sure area
is free of all electrical wires and pipes.
If you are unsure of this procedure or do not
have the proper equipment to locate electrical wires and pipes please
consult with a licensed contractor.
2. Once you are sure your area is clear locate
the studs and cut a hole in the drywall between the studs measuring 14
¼” wide x 50 ¼” high.
3. Slide Closet Vault into cut out area.
4. Using ¼” x 1” lag screws secure Vault into
sides of studs at hole locations inside Vault.
The Closet Vault’s frame will protrude 2” from
the wall’s surface allowing extra interior depth.
Interior Set Up
Bottom Foam liner sets in place.
The Barrel Support has an adhesive back for easy
placement, simply line up at the most convenient height location.
Caution: Check that the Barrel Support does not interfere with the lock
or the door will not properly close. The adhesive is very strong so be
sure of desired location prior to pealing backing off.
Optional full shelf:
Line shelf clips up in
desired location and set shelf in place, Check that the Shelf is not
just behind the lock or the door will not close properly.
Optional Half Shelf:
Slide shelf brackets
into side of Closet Vault at desired location, shelf may be used on
either right or left side.
Optional Pistol Caddy:
Slide bracket into side of Closet
Vault at desired location.
Optional “Pegboard” Door Panel
Slide “Pegboard” behind inside frame
of door.
Line up small holes in
“Pegboard” with holes in door frame and fasten screws in place to secure
“Pegboard”. Check objects hung on “Pegboard” that they do not interfere
with interior shelving. |
